Combi Victoria 8850 User Manual

Victoria™8850 SeriesInstruction ManualVictoria™Convertible Car SeatCorrect installation and use can be a matter of Life or Death! Read andunderstand t

179b.Forward-facing Installation With LATCHRefer to vehicle owner’s manual to identify the seating locations with LATCH System. Select the seating loc

19Connect lower anchor connectors to vehicle lower anchors.- With hook-on connector opening facing down , position the opening of the connector ove

21Refer to vehicle owner’s manual to identify the seating locations which can be used with a car seat. Check for specific instructions for car seat us

23Removal Of Car Seat Installed With Vehicle Seat Belt:Tip belt adjuster to loosen top tether strap (fig. g).Depress retainer spring and unhook

25Loosen harness: - Grasp shoulder harness strap BELOW harness cover.-While pressing on harness adjuster lever, pull out on shoulder harness strap.IMP

2711b. Changing Shoulder Harness Positions:Rear-facing - Shoulder harness straps must be through shoulder harness slots ator just below child’s should

291. Recline seat into rear-facing, fully reclined position #1.2. Positioning and attachment of harness covers:NOTE: If using car seat without harness

3111c. Infant Insert:•To prevent ejection:- Shoulder belts MUST be through belt slots in infant insert.- For proper harness fit, infant insert MUST be

33Manually adjustable lap belts (fig. c) normally will hold a car seat tightly. However, in some cases, the locking latch plate on some seat belts may

35Section 13 - Rear-facing Belt Lock-off• Failure to use the belt lock-off where required will result in car seat not being securely held in place.WAR

1Section 1 - Table of ContentsSection 1. Table of Contents...1Section 2. Warnings...

37Section 16 - Registration InformationChild restraints (car seats) could be recalled for safetyreasons. You must register this restraint to be reache

•Proper use is required. Read and understand instructions and car seat labels.•Securely install car seat with LATCH System or vehicle seat belt and to

5Section 5 - Use RecommendationsHeight and Weight Limits:This child restraint is designed for use only by children whose:-Weight is between 5 and 40 p

7Section 6 - Selecting A Vehicle Seating LocationThe National Highway Traffic Safety Administration (NHTSA) alerts vehicle owners that according to ac

9Section 7 - LATCH System(fig. b)(fig. a)2321LATCH System On This Car Seat:The LATCH System on the Victoria Car Seat consists of a lower anchor belt

11•LATCH belt MUST stay tightly adjusted around car seat at all times.• Only use the car seat LATCH System in vehicle seating locations designated by

Storage Of Lower Anchor Belt And Connectors:When not using the LATCH System, store the lower anchor belt and hook-on connectors by removing lower anch

15Thread vehicle lap belt or vehicle lap and shoulder belts through the rear-facing belt pathin the seat (fig. b):- Thread vehicle seat belt through r