SPERIANSURVIVAIR Opti-Fit™S-SeriesFull Facepiece Air Purifying RespiratorOperation and Maintenance ManualWARNINGDO NOT USE this respirator until you c
101051 Combination Organic Vapors and P1001052 Combination Acid Gases and P1001053 Combination Organic Vapors, Acid Gases, and P1001054 Combination Am
11Acroline Carbonyls Hydrogen Selenide OzoneAniline Cyanogen Methanol PhosgeneArsine Dimethylaniline PhosphineBoron Hydrides Dimethyl Sulfate Methylen
12WARNINGFilters improperly used or improperly assembled to the facepiece could cause leakage, which could lead to personal injury, illness, or dea
13NOTEWhen properly adjusted, the headstrap hub should be centered on the back of your head, and the lower straps should be below your ears.OPTI-FIT F
14VIII. HOW TO USE THE RESPIRATORTo receive the maximum protection available from your respirator, you must read, understand, and follow all the Warni
15replaced whenever they are damaged, soiled, contaminated with water, or as soon as they are too difcult to breathe through. Sperian recommends, due
16CAUTIONDo not use solvent type cleaners to clean any part of the respirator.NOTESilicone and rubber parts of the facepiece may be cleaned between wa
17WARNING• The failure to comply with this warning may lead to personal injury, ill-ness, or death.XIV. REPAIR (See the Repair Table)Repair by the use
18XVIII. ADDITIONAL INFORMATIONIf you need assistance or additional information on any SPERIAN product, consult your local distributor or contact:SPER
19XX. INSPECTION TABLEIF ANY OF THE DEFECTS LISTED ARE FOUND, HAVE THE RESPIRATOR REPAIRED BEFORE USE.COMPONENT LOOK FORFACEPIECE LENS 1. Nicks, scr
2Table of ContentsNIOSH CAUTIONS AND LIMITATIONS ... 3I. INTRODUCTION... 3II. SAFETY PRECA
20XXI. REPAIR TABLECOMPONENT INSTRUCTIONSHEADSTRAP REPLACE-MENT1. Remove the old headstrap from the facepiece, noting the routing of the straps.2. Ins
21XXI. REPAIR TABLE (Continued)COMPONENT INSTRUCTIONSLENS REPLACEMENT 1. Remove any cartridges and/or lters from the con-nectors.2. Use a 5/32 inch A
22www.sperianprotection.com
3NIOSH APPROVAL CAUTIONS AND LIMITIONSA - Not for use in atmospheres containing less than 19.5 percent oxygen.B - Not for use in atmospheres immediate
4NOTEMaintenance or operating procedures and techniques or information consid-ered important enough to emphasize.III. DESCRIPTIONThe SURVIVAIR Opti-Fi
5WARNING—Continued• Do not use this respirator at ambient temperatures above 130°F (55°C).• Do not use this respirator where environmental conditions
6WARNING—Continuedsensitizers. Use positive pressure supplied air respirators to provide better protection from these chemicals. Do not use
7IV. PARTS LIST (See Figure 1)ITEM QTY P/N DESCRIPTION1a 1 702009 Headstrap, TPE1b 1 702089 Headnet, Mesh, Opti-Fit2 1 962157 Small Skirt, Silicone1 9
8Note: Quantities in parentheses are for headnet conguration only.Optional Accessories702019 Peel-away Lens Cover, Tinted (25)702028 Peel-away Lens C
9Table 1. Cartridges and Filters (S-Series)(See NIOSH Approval Label for Specific Contaminants)MODEL FILTERS1050 P1001060 Filter Pad, N951070 Filter P
Comments to this Manuals